Choke And Control Valve (BANDUNG)

Tanggal
14 – 17 January 2013
5 – 8 March 2013
29 April – 2 May 2013
24 – 27 June 2013
2 – 5 September 2013
11 – 14 November 2013

Jam Pelaksanaan
09.00 – 16.00 WIB

Tempat
Hotel Kagum Group Bandung (Golden Flower, Banana Inn, Grand Seriti, Carrcadin, Amaroossa, Grand Serela, Gino Feruci, Verona Palace, Malaka, Zodiac Taurus)

Pembicara / Fasilitator
Ir. Deddy Nugraha is a dedicated experienced fulltime trainer and technical consultant since 2002. He holds a B.S. degree in Mechanical Engineering from ITB, Bandung. He has worked nationally in a wide variety of industries including: technology, aerospace, utilities, auditing, mining and institutions thus engaged as a corporate consultant. He also holds certifications for those particular fields from Snecma, France; Engine Support Inc., USA; Danobat, Spain; DNV, Singapore; MTU, Germany and FAA Auditor, USA. Mr. Nugraha is a member of Indonesian Society for Reliability and was elected as General Sectretay for 2004-2007 period. He has trained hundreds of managers, engineers and floor associates, subjects taught to include; CMMS, RCM, TPM, Project Management, Quality Process Control, Corrosion Control and Protection, Failure Analysis, Engineering Design, Instalation & Constrcution, Inventory Control and Management. Major clients include: Pertamina, British Petroleum, Petrochina, Siemen Power, PT. Indonesia Power, PT. Krakatau Steel, Freeport Indonesia, PT. Surveyor Indonesia, Chevron, Medco Energy, PT. Aneka Tambang, Garuda Maintenance Facility, PT. Perusahaan Gas Negara, PT. Semen Padang, PT. Semen Gresik, PT. Indah Kiat Pulp & Paper, PT. Tjiwi Kimia, PT. Pupuk Kujang and PT. Kaltim Prima Coal.

INVESTATION PRICE/PERSON :

Rp 7.500.000/person (full fare) or
Rp 7.250.000/person (early bird, payment 1 week before training) or
Rp 6.950.000/person (if there are 3 or more participants from the same company)

FASILITAS UNTUK PESERTA :

Modul Training
Flash Disk berisi materi training
Sertifikat
ATK: NoteBook dan Ballpoint
T-Shirt
Tas
Foto Training
Ruang Training dengan fasilitas Full AC dan multimedia
Makan siang dan 2 kali coffeebreak
Instruktur yang Qualified
Transportasi untuk peserta dari hotel penginapan ke hotel tempat training – PP (jika peserta minimal dari satu perusahaan ada 4 peserta)

INTRODUCTION :
This course is a practical knowledge of selection, installation of choke and control valves. Design, specification and implementation of control and operation in gas plant process.

TRAINING MATERIAL OUTLINE :

Basic physical properties
Fundamental of measurement
Fundamentals of flow characteristics
Control valves
Pressure drop
Flow equations
Fundamental valve sizing
- a. Introduction
- b. Definition of a Control Valve
- c. Energy Type
- d. What is happening inside a control valve
- e. Cavitation
- f. Flashing
- g. Choked Flow
- h. Valve Coefficient Cv
- i. Valve characteristic
- j. Equal percent
- k. Linear
- l. Quick opening
- m. Selection method
HIGH PRESSURE DROP APPLICATION/CHOKE VALVE
- Cavitation Control
- Cavitation Elimination
- Low Noise
- Diffuser Plates
- Chokes
- Disk Stack Technology
- Pressure Balance Trim
Control valve selection
Installation