Training Programmable Logic Controller & Trouble Shooting
April 26-29, 2011 at Bandung
WHY SHOULD ATTEND?
This course is designed to benefit participants with practical up-to-date information on the application of PLCs to the automation and process control of plants and factories. It aims to give practical advice from experts, to assist participants to correctly plan, program and install a PLC with a shorter learning curve and more confidence. The information contained in this course advances from the basics to challenge even the most experienced engineer in the industry today.
WHO Should attend?
• Instrumentation and Control Engineers
• Electrical Engineers
• Design Engineers
• Consulting Engineers
• Instrumentation Technicians
• Process Control Engineers
• Engineering Managers
COURSE ITINERARY:
DAY I
1. Introduction
2. PLC Components
3. PLC Operation
4. Response Time PLC
5. Interrupt Function
6. Relay
7. PLC Basic Instructions
8. PLC Registering and Its Operation
9. Program Scanning
DAY II
1. Types of Counter
2. Timer, On Delay Timer, Off Delay Timer
3. Getting & Moving Data, LDA, STA
4. Mathematic Function in PLC
5. Numeral System, Biner, Octal, Hexadecimal
6. Boolean Mathematic, AND, OR, EXOR
7. DC & AC input to PLC
DAY III
1. Relay Output
2. Transistor Output
3. RS-232Communication, Data Terminal
Equipment (DTE), Data Communication
Equipment (DCE)
4. Start bit, Stop bit, bit parity, baud rate
5. PLC Making: Ladder Diagram
DAY IV
Laboratory Practical Activity using PLC-05 AB and SLC-AB
Instructor:
DR. Sutanto Hadisupadmo; He has more than 15-years experiences as instructor on Instrumentation, Measurement Control & System, PLC, DCS Programming, Advance Process Control, etc. His professional education started on Engineering Physics, Bandung Institute of Technology (ITB-1977), Diplome Universite in Energetique, Universite de Prepignan, France (1985), Magister Engineering in Instrumentation and Control (ITB) and Doctor (ITB). As lecturer at Department of Engineering Physics Department-ITB, he active doing research, writes book/hands-out and published. As professional he has handled many projects in Instrumentation Process, Tools Evaluation, Transmitter, General Instrumentation Specification Evaluation, Commercial Building Power Audit, Maintenance Management Evaluation, etc. To get more advance information and knowledge he has participated in domestic and overseas training, seminar, course and conference as participant or speakers.