ELECTRICAL GROUNDING AND SHIELDING ELECTRONIS SYSTEM
Tanggal
9-11 November 2011
Jam Pelaksanaan
08.00 – 16.00 WIB
Tempat
Santica Hotel Jogjakarta
ABSTRACT
This course stresses the fundamental electromagnetic compatibility principles involved in typical grounding and shielding problems. Understanding the objectives and techniques for grounding and shielding will reduce misconceptions and allow a more systematic approach to replace trial and error methods. For example, the course explains why a signal ground is not the same as a signal return.
Also, solutions for the numerous problems caused by wiring inductance are described and demonstrated. The course emphasizes the development of logical diagnostic techniques for identifying various types of noise problems. Often, the correct identification of the problem is more difficult than the solution. The course is at an introductory level; however, some knowledge of electronic circuits and system design is assumed. Several interference mechanisms and shielding techniques are demonstrated.
COURSE CONTENT
I. Basic Principles of Noise Reduction
1. Importance of wiring inductance
2. Bandwidth of pulse waveforms
3. Noise coupling mechanisms
4. How to identify the mechanism
5. Common and differential modes
II. Grounding: Why and How?
1. What is electrical ground?
2. Reasons for grounding
3. Signal ground, signal return
4. Ground grid technique
5. Isolated grounding technique
6. Ground loop noise reduction
III. Signal Ground Techniques
1. Ground each current only once
2. Unsafe signal grounding
3. Single point versus ground grid
4. Signal isolation techniques
IV. How to Diagnose Noise Problems
1. Ringing, rounding, and reflections
2. Effects of signal impedance distribution on susceptibility
3. Practical diagnostic techniques
4. Noise coupling examples
V. Noise Reduction Techniques
1. Filtering and shielding
2. Reducing mutual inductance
VI. Filtering Conducted Noise
1. CM and DM filter techniques
2. Improving circuit balance
3. 1 GHZ filtering techniques
4. DC power bus design
VII. Inductive and Capacitive Shielding
1. Self-shielding techniques
2. Misuse of twisted pair
3. Grounding cable shields
4. Shielding examples
VIII. Reducing Electromagnetic Coupling
1. Identifying EM coupling
2. Controlling CM currents
OBJECTIVE
This course is designed to enable participants to:
- Define electrical ground, signal ground, and signal return
- Describe various grounding techniques
- Diagnose noise problems
- Identify methods to reduce and filter noise
- Define inductive and capacitive shielding
- Describe techniques for reducing electromagnetic coupling
- Select appropriate cabling
- Identify methods to ensure impedance matching
- Identify noise coupling mechanisms
INSTRUKTUR
Ir. Teguh Santoso
Ir. T. Haryono, M.Sc., CEng MIEE
WHO WILL BENEFIT/PARTICIPANT
This course is recommended for electrical engineers, technicians, designers and release engineers responsible for electronic or electromechanical products.
COURSE METHODS
• Pre-Test
• Presentasi materi
• Case Study
• Group Case Discussion
• Post-Test
• Evaluasi
FACILITIES
- Training Kit
- Meeting room Hotel ***
- 2x Coffe Break and Lunch
- Souvenir
- Additional Programm (optional)
COURSE TUTION
Rp.6.500.000,-/Participant Non residensial
For send 3 Participant IDR : 6.000.000,-/participant NONResidensial Training Kit ( Tas seminar, ATK, Handout)
